Xilica XD Series Uživatelský manuál

XConsole GUI setup communication manual September 2010. XConsole is compatible with Microsoft XP, Vista and Windows 7. The software will also

Make sure the “Launch the CP210x...” box is checked before proceeding by clicking “Finish”. You are now prompted if You would like to change t

The installation is complete, click “OK” to close the XConsole wizard. When upgrading from a previous version, the installation wizard will det

The following pop-up appears select “Modify” and click “Next” Make sure the box next to “CP210x...” is checked and select “Next” to proceed.

The installation wizard has now finished the update, select “Finish” to complete. The driver and the software should now be properly installed

The following screen pops up, prompting You if You would like to connect to the device. In this example we have deliberately not switched on t

Now the following screen appears, as You can see there is no device connected. Double click to try and connect. Once again You are now promp

The next screen pops up, as You can see there is a direct link to the device manager in this menu. before opening the device manager we switched o

You can now see which COM port is assigned in the device manager (in this case COM port 3) make sure this port is also assigned in the XConsole se

After clicking “OK” close the software with the “X” in the upper right corner of the window Now reopen the XConsole You will see the devic

XConsole and the related USB driver are installed and you should have established solid communication using the front panel USB connector.

INSTALLATION: Once the zip file has been extracted, open the folder and double-click “XConsole setup”. At this point, you might be requested to

Navigate to find the required .Net Framework installer and begin the .NET Framework 3.5 installation on your computer by double clicking the file sh

After a successful installation, please finish by clicking “Exit”. Now please reboot your computer to activate the new settings. Once the compute

Another pop-up apears prompting You where to install the shortcut. To proceed, click “Next”. The following pop-up appears select “Install” to

The installation starts indicated by a dark blue progress bar. Click “Finish” to start the driver installation procedure. This will enable th

The computer starts searching for previous installed drivers and comes up with the following screen during it’s search. If this is the first

Accept the license agreement to proceed with the installation. You are now prompted where to install the software and drivers. Proceed by click

The wizard is ready for installation select “Install” to continue. The installation starts indicated by a progress bar.